Sealtite Waterproofing & Caulking
SERVICE · 10 YR WARRANTY

Wet Area Waterproofing

Every shower, bathroom and laundry gets built to AS 3740:2021 — no exceptions. We install Class III membranes with certificates.

The Problem

Non-compliant membranes fail early and void insurance. Cheap sealant at wall-floor junctions cracks within a year.

Our Solution

Ardex Shower System — primer, bond breaker at all vertical/horizontal junctions, 2-coat liquid membrane with reinforcement fabric, flood test.

02TYPICAL BUILD-UP

Cross-section.

WET AREA WATERPROOFING — TYPICAL SECTION
SUBSTRATE — CONCRETE01 FINISHTile / paver / topping02 SCREEDFalls to drain 1:8003 MEMBRANEArdex WPM 300 · 1.5mm DFT04 PRIMERArdex WPM PrimerSECTION
03SCOPE OF WORKS

What we deliver.

01
Substrate prep
Fill, sand, prime — CFC sheet or screed
02
Bond breakers
Ardex STB at all internal corners and penetrations
03
Membrane
2 coats Ardex WPM 300 at 1.5mm total DFT
04
Reinforcement
Fabric at floor waste, hobs and penetrations
05
Certificate
AS 3740:2021 compliance certificate issued
04FAQ

Common questions.

What is Class III?+

The highest membrane class under AS 4858 — required for showers over habitable rooms and areas with structural movement.

Do you provide the compliance certificate?+

Yes — required in Victoria and part of every job.

Can we tile the same day?+

No. Membrane must cure fully — typically 24 hours minimum before tiling.

What changed in AS 3740:2021?+

Tighter fall requirements, extended membrane heights in showers without screens, and clearer detail at hobless showers.

Do you do the tiling too?+

We're specialist waterproofers. We coordinate with your tiler and hand over a certified substrate.

05RELATED PROJECTS

Recent work in this scope.

Ready to spec this scope?

CallQuoteEmergency